The JETLY FORACTIVE DCS4 deep wells submersible borehole pump is composed of a 4" submersible pump, with ACTIVE DRIVER variable speed drives, a 30 m or 40 m cable, and a suspension cord. The variable speed drives permit to provide a constant pressure for any flow you want. Maximum flow rate to 6 m3/h.
Less than 5 days
Warning: Last items in stock!
- From 0,6 m3/h to 6 m3/h with total discharge heighter until 100 meters of water column.
- Pumped liquid : clean, without solids particules, or abrasive, non-aggressive, non-viscous, non-crystalline and chemically neutral.
- Temperature of pomped liquid : from 0 °C to + 30 °C.
- in wells, bore of 4 inches or more, basins, cisternes, and can work in vertical position.
Advantages of FORACTIVE :
- don't need of big tank (8L).
- work without electric control unit and dry-running protection.
- only one setting = designated pressure.
- the constant pressure enable an high flexible operating.
- no water hammer possible.
- efficiency of engine enable saving energy.
- high life pump.
Characteristics hydraulics of the DSC4 pump :
- Multi-stages pump, with turbine and diffusor in technopolymer.
- Sleeve, shaft, coupling sleeve, bearings, paliers, stainless steel screws.
- sand slinger (abrasion-resistant), very high résistant.
- Connection flange with in-built strainer in technopolymer.
- In-built non-return valve in resin.
- Standard norme (CE).
Electrical characteristics of DSC4 + pump with ACTIVE DRIVER :
- Encapsulated submersible motor, asynchronous, 2 poles (2800 rpm) DAB single-phase or three-phase 230V.
- Complete in stainless steel AISI 304.
- Rotor designed to axial loads.
- Maximum start-up nomber to 20/h.
- Indice of protection : IP 68.
- Classe : B.
- Protection of ACTIVE DRIVER : dry running, amperometric, overheated of the electronic part, anomalous voltage, direct short-circuit between outup phases, automatic restart after electric defect.
* Provide with the pompe : the ACTIVE DRIVER variable speed drives, 30 m or 40 m electric cable, 1 x 30 m or 40 m nylon cord.
||DCS4C-19 AD||DCS4D-13 AD|
|Single-phase voltage (V)||230|
|Voltage motor (V)||1 x 230||3 x 230|
|Maximum intensity (A)||6.2||5.7|
|Variable flow (m3/h)||from 1 to 2.5||from 1 to 3||from 1 to 4|
|Maximum TDH (m C.E)||71.5||104.5||78|
|Maxi. pressure (bar)||7||10||7.7|
|Temperature of liquid||0°C à + 30 °C|
|Water bath lubrificated IP 68||DAB|
+ nylon cord (m)
|Ø of pump (mm)||97|
|Ø of discharge (BSP)||1" 1/4 G (33x 42)|
The FORACTIVE system is easy to install. After hydraulic connection and power supply, you have just to set the flow rate on ACTIVE DRIVER.
Customer ratings and reviews