Float switch - Regulator of level

Float switch is a device for the detection of level of liquid within a reservoir.

Variable speed drives
Water pump control panel
Pressure switch
Pump automation
Float switch - Regulator of level
Motor protection circuit breaker
Cable
Coupling
Level regulator
Pressure control
Condensator
Solenoid valve
Régulateur de niveau vertical réglable AGMA W Régulateur de niveau vertical réglable AGMA W 2
2 to 4 days
Float switch - Regulator of level
AGMAW EVO vertical magnetic level controller
001414
€63.33

€63.33 tax excl.

Delivery 2 to 4 days

Level controller for a single-phase lift pump up to 1.50 Kw max, installation with clear, waste or loaded water pump, vertical mounting with two fixing holes, adjustable on/off differential, 5 to 15 cm, 3G1 mm² electric cable of 25 cm.
Interrupteur à flotteur pour liquides agités AT 120
2 to 4 days
Float switch - Regulator of level
AT 120 float switch for agitated liquids
001418
€101.67

€101.67 tax excl.

Delivery 2 to 4 days

For use with agitated, clear, waste and loaded water, this float level switch (On/Off) allows direct automation of pumps (up to 1.5 HP) or unlimited via a contactor. Differential angle of 120°, which allows a smooth contact to be established, and allows both the high level and the low level to be detected in the same tank.
Régulateur de niveau à flotteur ATEX
2 to 4 days
Float switch - Regulator of level
ATEX float level controller
001421
€135.83

€135.83 tax excl.

Delivery 2 to 4 days

TAURUS Ex float level controller, activation angle 20°, float with double sealed pressure-resistant chamber, cable RN8-F 4G 0.75, ATEX II1G Exia II C T6/T5 Ga certified.
Interrupteur à flotteur ATEX Interrupteur à flotteur ATEX 2
2 to 4 days
Float switch - Regulator of level
ATEX float switch SUPERTEC EX
001411
€130.00

€130.00 tax excl.

Delivery 2 to 4 days

ATEX float switch, versatile for clean liquids, waste water and industrial water, switching angle +/- 45°, ATEX II 1G Ex ia IIC T6 compliant, double-layer float, pressure resistant.
Relais de sécurité intrinsèque ATEX
2 to 3 days
Float switch - Regulator of level
ATEX intrinsic safety relay
001417
€255.00

€255.00 tax excl.

Delivery 2 to 3 days

The intrinsic safety relay, with galvanic isolation, is used to connect sensors, contacts and proximity detectors located in an ATEX zone, it is used to limit the electrical energy circulating in the ATEX zone, and to relay the on/off signals of a contact or detector.
Interrupteur de niveau Eau potable
2 to 4 days
Float switch - Regulator of level
ATS 165 EP - ACS certified float level switch
€180.00

€180.00 tax excl.

Delivery 2 to 4 days

ATS 165 EP, ACS certified float level switch use in extremely agitated drinking water applications. Switching angle : + or - 165°. Maximum pressure : 3,5 bars
Boitier alarme sonore niveau cuve - SENTINEL Boitier alarme sonore niveau cuve - SENTINEL 2
Last items in stock
Float switch - Regulator of level
Audible tank overflow alarm unit - SENTINEL
008185
€71.67

€71.67 tax excl.

Last items in stock

Connected to a 2P+T power socket, and wired to a level switch placed in a tank, it activates a siren according to the liquid level, built-in buzzer, 9V backup battery (in the absence of power), fitted with an output relay with potential-free contacts, to activate a remote alarm signal.
Lest clipsable pour interrupteur à flotteur NEW-T
2 to 3 days
Float switch - Regulator of level
Clip-on weight for float switch
001359
€13.33

€13.33 tax excl.

Delivery 2 to 3 days

Clip-on weight for the electric cable of a Mac 3 float level regulator, FLO-STOP.
Boitier de commande et protection pompe de relevage monophasé
Motor protection circuit breaker
Control and protection box for single-phase lift pump
To automate a single-phase lift pump, AT-120 float switch for agitated, clear, waste and loaded water, Schneider box with on/off button, thermal reset, power contactor + thermal protection relay, control by float switch in the tank.
View
Boitier de commande et protection pompe de relevage triphasé
2 to 4 days
Motor protection circuit breaker
Control and protection box for three-phase lift pump
€280.00

€280.00 tax excl.

Delivery 2 to 4 days

Control and protection box for a three-phase lift pump from 0.55 Kw to 11.00 Kw, AT-120 float switch for agitated, clear, waste and loaded water, Schneider box with on/off button, thermal reset, power contactor + thermal protection relay, control by float switch in the tank.
Contre-poids pour interrupteur à flotteur
2 to 3 days
Float switch - Regulator of level
Counterpoise for float switch
001358
€4.17

€4.17 tax excl.

Delivery 2 to 3 days

Cylindrical high-density PVC counterweight, filled with ballast. Used to adjust the tripping level of the float switch. Can be used with CE and IF models.
Détecteur de niveau 3 mm EASY FLOOD Détecteur de niveau 3 mm EASY FLOOD 2
2 to 3 days
Float switch - Regulator of level
EASY FLOOD 3 mm level detector
001415
€207.50

€207.50 tax excl.

Delivery 2 to 3 days

Ideal for a flush-to-floor lift pump, for the total drying of flat surfaces where there is no manhole available to house a basement drainage pump. The pump starts from 3 mm above the floor.
Interrupteur de niveau à flotteur BIP STOP Interrupteur de niveau à flotteur BIP STOP 2
2 to 3 days
Float switch - Regulator of level
FLO STOP float level switch for small pumps
€30.00

€30.00 tax excl.

Delivery 2 to 3 days

FLO STOP Float level switch for small pumps for application with slightly aggressive liquids, and highly appreciated in agitated liquids - Switching angle + or - 110º - Maximum pressure : 3,5 bars.
Float switch + 2P remote-control connection plug
2 to 4 days
Float switch - Regulator of level
Float switch + 2P remote-control connection plug
€66.67

€66.67 tax excl.

Delivery 2 to 4 days

Float switch with 16A 250V 2P+e, automatic control of the pump according to the level. The power plug pump is connect on Schuko plug. Available with cable from 5 to 20m.
Float switch + 2P remote-control connection plug
2 to 4 days
Recovery of rainwater
Float switch + 2P remote-control connection plug
€70.83

€70.83 tax excl.

Delivery 2 to 4 days

Float switch with 16A 250V 2P+e, automatic control of the pump according to the level. The power plug pump is connect on Schuko plug. Available with cable from 5 to 20m.
Float switch + 2P remote-control connection plug
2 to 4 days
Float switch - Regulator of level
Float switch + 2P remote-control connection plug
€66.67

€66.67 tax excl.

Delivery 2 to 4 days

Float switch with 16A 250V 2P+e, automatic control of the pump according to the level. The power plug pump is connect on Schuko plug. Available with cable from 5 to 20m.
Float switch + 2P remote-control connection plug
2 to 4 days
Float switch - Regulator of level
Float switch + 2P remote-control connection plug
€70.83

€70.83 tax excl.

Delivery 2 to 4 days

Float switch with 16A 250V 2P+e, automatic control of the pump according to the level. The power plug pump is connect on Schuko plug. Available with cable from 5 to 20m.
Interrupteur à flotteur pour pompe vide cale Interrupteur à flotteur pour pompe vide cale 2
2 to 3 days
Float switch - Regulator of level
Float switch for bilge pump
001405
€40.00

€40.00 tax excl.

Delivery 2 to 3 days

Float switch for 12 or 24 volt bilge pump, automatic pump operation according to the water level, starts at 55 mm and stops at 25 mm from the floor, max 10 amps, above that, use a relay.
Float switch fill / empty - Mac3 Float switch fill / empty - Mac3 2
2 to 4 days
Float switch - Regulator of level
Float switch Mac3 - fill / empty
€29.17

€29.17 tax excl.

Delivery 2 to 4 days

The Mac3 type floating switch is suitable for filling and emptying, sewage in shafts, tanks, basins or cisterns...
Détecteur de niveau ras du sol - CRAB Détecteur de niveau ras du sol - CRAB 2
2 to 4 days
Float switch - Regulator of level
Floor water detector
001412
€181.67

€181.67 tax excl.

Delivery 2 to 4 days

Placed on a flat surface, the CRAB detector can detect the presence of water on the floor from 3 mm, thanks to two low probes, suitable for single-phase lift pumps without float, low suction, supplied with 10 metre cable + remote control plug.
Interrupteur à flotteur universel FOX - G09
2 to 3 days
Float switch - Regulator of level
FOX - G09 universal float switch
001419
€60.83

€60.83 tax excl.

Delivery 2 to 3 days

The FOX - G09 float switch allows direct control of a single-phase lift pump up to 2.20 Kw, used for clear and waste water, activation angle 45°, max liquid temperature 70°C.
Interrupteur à flotteur liquides chimiqudes - hydrocarbures - Taurus FEP
2 to 3 weeks
Float switch - Regulator of level
Level controller for chemical liquids - hydrocarbons - Taurus FEP
001413
€330.00

€330.00 tax excl.

Delivery 2 to 3 weeks

FEP level regulator, with triple sealed chamber, unlike traditional floats that float on the surface of the liquid, the TAURUS FEP remains underwater. Used to adjust the minimum and maximum levels, in pairs, and can also be used as an alarm regulator.
Showing 1-24 of 38 item(s)

Practical information

Need advice? Our team is available (Monday - Friday: 8:30-12:00 and 13:00-16:30).

Contact us

Delivery

  • Same-day dispatch for orders placed before 12 noon, in most cases.
  • Colissimo without signature in mainland France, delivery within 2 to 3 days.
  • Chronopost on request.
  • DB SCHENKER transport for oversized parcels: delivery to your freight forwarder in France, with guaranteed tracking.
Delivery terms

Advice and guides

Go to our guides

Floats and regulators to control a pump by level

A float switch or level regulator starts or stops the pump when the liquid rises or falls in a sump, a pit, a tank or a pond. The contact is operated by the float position, which follows the liquid level.

Choosing by liquid and use

  • Type of liquid: clean water, loaded or waste water, drinking water, chemicals or hydrocarbons.
  • Float and cable material, compatible with the liquid.
  • Cable length and adjustment of the switching height.
  • Hazardous areas: some models are designed for this use; the product page gives the conditions.

Frequently asked questions: Level detection

Which float for waste water?

A regulator designed for loaded water, with a smooth body and often an integrated weight, reduces snagging. The product page states the liquid it accepts.

Can I use a float with drinking water?

Only models designed for drinking water should be used. Check the product page for the food-contact conformity mention and follow the manual.

Do acids or hydrocarbons need a specific model?

Yes: choose a regulator whose materials are compatible with the product. In an explosive atmosphere, use only a model designated for it and follow the manufacturer's instructions.

Do you need advice before buying?

Our team helps you choose the right equipment for your installation: call +33 3 44 25 91 01 Monday to Friday, 8:30 am to 12:00 pm and 1:00 pm to 4:30 pm (French time), or email contact@pompes-h2o.com. Public bodies can pay by administrative order (mandat administratif), with invoicing through Chorus Pro.